Cause:
This may occur because of wearing of the developer, drum unit, or charger.
Solution:
1. If a message prompting replacement of a unit has appeared, replace the unit.
2. In the [Machine: Image Quality] group on the [Adjustment Settings for Skilled Operators]
menu, select [Adjust Image Density] and execute [Image Density Adjustment: Manual
Execute].
3. Print the image. Is the problem resolved?
Yes Finished!
No In the [Machine: Maintenance] group on the [Adjustment Settings for Skilled Operators]
menu, execute [Execute Process Initial Setting].
4. If the problem persists, contact your service representative.
Ghosting
A ghost image of an image to be printed appears at a distance of 314 mm (12.4 in.) to the side of the
intended image.
Toner Spotting/Staining
25
To Next Page
Loading...
