No Decrease the value by 1 in [Adjust Toner Adhesion].
8. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Steps 5 to 7. If the problem persists even though you have decreased the
value to the lower limit, contact your service representative.
Toner Scatter (3)
Parts of a line or character exhibit splatter. This may occur in a line or character that is 8 to 13 mm (0.3
to 0.5 inches) from the trailing edge and 20 mm (0.8 inches) or less from the left edge facing the paper
feed direction.
Cause:
A shock jitter occurs when the trailing edge of the paper leaves the paper guide during paper transfer
and causes toner scattering.
This may occur if paper with a thickness equivalent to Paper Weight 4 or higher is used.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings Reference.
• Changing the transfer current may produce either or both of the following side effects:
• Reduction in toner yields
• Occurrence of banding (streaks)
Toner Scatter
31
To Next Page
Loading...
