Cause:
This may occur if printed at low temperature or humidity.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings Reference.
Solution:
1. Check both sides of the paper for the problem. If this problem appears only on the side 2
of the paper, skip to Step 3.
2. Adjust the setting for the side 1 of the paper. In [Advanced Settings] for the custom paper
in use, increase the absolute value of the negative current by 5% in [Paper Transfer
Current Setting: Side 1].
Example: If the present current is −40 A, change it to −42 A.
3. Adjust the setting for the side 2 of the paper. In [Advanced Settings] for the custom paper
in use, increase the absolute value of the negative current by 5% in [Paper Transfer
Current Setting: Side 2].
Example: If the present current is −40 A, change it to −42 A.
4. Print the image. Is the problem resolved?
Yes Finished!
3. Troubleshooting Image Quality Problems
28
To Next Page
Loading...
