Prohibit Transition to Energy Saver Mode
Specify how long it takes to switch to Energy Saver when the printer is left idle.
You cannot use Image Quality Monitor Console if the printer's power is switched off or the printer
switches to Energy Saver mode.
Thus, when using Image Quality Monitor Console, specify this setting to prevent the printer from
switching off.
You can specify this setting between 0 and 99 minutes. As the default, it is set to 15 minutes.
• Energy saving transfer-prohibited time is the time when there is no communication with the server.
Therefore, operations such as sorting and account setting on the Image Quality Monitor console do
not cause communication with the server, so the migration prohibition time is not reset.
Backup/Restore
You can back up and restore the settings specified on the [Management] tab.
You can back up the current values of the following settings:
• Custom presets
• Account
• Network Settings
• Prohibit Transition to Energy Saver Mode
• Back Up and Restore cannot be performed while printing.
Back Up
Use this to store the current settings locally.
Restore
Use this to read and restore backup data.
After reading is complete, Image Quality Monitor Console is rebooted.
Management
37
To Next Page
Loading...
