When to use
Use this when the glossiness of the printed sample is not satisfactory.
• Gloss Level
As the default, this is set to "0" among the 5 levels consisting of -1, 0, +1, +2, and +3. If the
print is too glossy, select "-1". If it lacks glossiness, select "+1" through "+3".
By adjusting the required temperature and line speed, you can control the heat applied to the
paper and change the glossiness.
• Correct Temperature
The heat (≈ required temperature) and glossiness are decreased by "-" and increased by "+".
Fusing Temperature Environment Correction
1252 [Fusing Temperature Environment Correction]
Function
Set the amount of environmental correction for the fusing temperature during paper feeding.
When to use
In a low temperature environment, the toner fusibility may be affected, so make corrections to raise
the required temperature.
In a high temperature environment, the heat may become too high, so make corrections to lower
the required temperature.
3. Details of Detailed Settings
42
To Next Page
Loading...
