Face curl Back curl
Sheets float up and tend to result in double-
feeds.
Sheets get pressed down and tend to result in
non-feeds.
Side Fan Level
1302 [Main/2-Tray LCIT: Fan/Shutter] [Side Fan Level]
Function
Adjusts the amount of air blown from the side fans to separate the sheets.
When to use
If double-feeds do not improve by setting 1301: [Main/2-Tray LCIT: Paper Feed Mode] to
[Prevent Double Feed (Weakest Blow)], decrease the airflow in [Updraft Fan Level] in steps of
10%.
If paper misfeeds persist even after changing the air flow in 1301 [Main/2-Tray LCIT: Paper Feed
Mode] to [Prevent Non Feed (Strongest Blow)], try increasing the air flow in steps of 10% along
with the value for the updraft fan level.
Face curl Back curl
Sheets do not separate well because air does
not flow in between the sheets. Also, the sheets
tend to float up and result in double-feeds.
Sheets do not separate well because air does
not flow in between the sheets. Also, the sheets
tend to get pressed down and result in non-
feeds.
Vacuum Fan Level
1302 [Main/2-Tray LCIT: Fan/Shutter] [Vacuum Fan Level: Main]
Paper Feed/Delivery
45
To Next Page
Loading...
