Increasing the length of time for the fan to operate enhances the degree of paper separation, but it
also increases the intervals between paper feeding and may reduce the throughput.
Related Troubleshooting
• Double Feeding
• Paper Misfeeds
For detailed procedure, see the Troubleshooting manual.
Prevent Initial Nonfeed
1303 [Main/2-Tray LCIT: Other Setting] [Prevent Initial Nonfeed]
Function
Adjust the amount the bottom plate is raised immediately after paper feeding starts.
When to use
Set this to [On] if paper misfeeds frequently occur immediately after the paper is fed.
Tray Elevation Assist(Assist Mode)
1303 [Main/2-Tray LCIT: Other Setting] [Tray Elevation Assist] [Assist Mode]
Function
Specify the operation to assist raising the bottom plate according to paper thickness.
When to use
If paper misfeeds frequently occur when the paper almost runs out, set this to [Assist On When
Remaining Paper Low]. If paper misfeeds frequently occur regardless of the remaining paper, set
this to [Always Assist On].
Related Troubleshooting
• Double Feeding
• Paper Misfeeds
For detailed procedure, see the Troubleshooting manual.
Tray Elevation Assist(Paper Thickness)
1303 [Main/2-Tray LCIT: Other Setting] [Tray Elevation Assist] [Paper Thickness]
Function
Specify the paper thickness to apply when the assist mode in [Tray Elevation Assist] is set to On.
3. Details of Detailed Settings
48
To Next Page
Loading...
