Paper Output: Entrance Roller/Decurler Switchback Roller/Cooling Transport Belt
1331 [Motor Speed] [Speed Adjustment] 08: [Paper Output: Entrance Roller]
1331 [Motor Speed] [Speed Adjustment] 09: [Decurler Switchback Roller]
1331 [Motor Speed] [Speed Adjustment] 10: [Cooling Transport Belt]
Function
Adjusts the motor speed of the above units.
When to use
Paper transport speed is inconsistent among the roller, causings the paper to bend and the guide
plate(s) to scratch the fused image.
This problem may be solved by adjusting the line speed to eliminate the slack in the paper.
Image Detection Feed Speed Mode
1331 [Motor Speed] [Speed Adjustment] 11: [Image Detection Feed Speed Mode]
Function
You can adjust the value for reducing the scanning speed fluctuation in the sub-scanning direction
when using Image Quality Monitor.
When to use
If erroneous detection occurs at certain locations, adjust the setting. For details, see the Auto Color
Diagnosis / Image Quality Monitor Guide.
Transfer Timing Roller (Prev Mag Error Corr With Fd)
1331 [Motor Speed] [Speed Adjustment] 13: [Transfer Timing Roller (Prev Mag Error Corr With
Fd)]
Function
In this mode, you can change the transfer timing roller line speed in order to minimize the
difference in the side-to-side magnification between those covering high image and low image
areas.
When to use
Use this if image degradation occurs after executing [Image Magnification: Across Feed] and you
wish to restore the machine to the previous state.
Paper Transfer Belt (Prev Mag Error Corr: With Feed)
1331 [Motor Speed] [Speed Adjustment] 14: [Paper Transfer Belt (Prev Mag Error Corr: With
Feed)]
3. Details of Detailed Settings
54
To Next Page
Loading...
