Ricoh SP 311DNW - Page 39

RICOH SP 311DNw B&W Network Laser Printer
Getting Started Guide
39
Authentication
Select authentication method:
• Open System
• Shared Key
• WPA2-PSK
• Mixed Mode WPA/WPA2
Note: If Ad Hoc is selected for [Communication Mode], you can select only [Open
System] and [Shared Key].
Encryption
Select an encryption method.
If [Ad-Hoc] is selected for [Communication Mode], you can select only [None] and
[WEP].
• [None]
When it is ON, communication will not be secured by encryption.
• [WEP]
When it is ON, communication will be encrypted in WEP (Wired Equivalent
Privacy).
Specify [WEP Key Length], [WEP Transmit Key ID], and [WEP Key Format] and
enter [WEP Key]. The following table shows the number and types of characters
you can enter, depending on the key settings.
WEP Length is 64 bits
WEP Length is 128 bits
WEP format is Hex
WEP format is
ASCII
WEP format is
Hex
WEP format is
ASCII
WEP Key Max.
Length
10 characters
5 characters
26 characters
13 characters
WEP Key Valid
Characters
0-9, A-F, a-f
0x20-0x7e
0-9, A-F, a-f
0x20-0x7e
•
[WPA2-PSK]
When this is selected, communication will be encrypted with WPA2 (Wi-Fi
Protected Access 2). Enter a value in [WPA Passphrase] that contains from 8 to
64 characters.
• [Mixed Mode WPA/WPA2]
When this is selected, communication will be encrypted with WPA (Wi-Fi
Protected Access) or WPA2 (Wi-Fi Protected Access 2). Enter a value in [WPA
Passphrase] that contains from 8 to 64 characters.
7. When finished, click [Apply]
 [OK] to save changes, and then click [Close].
8. Turn printer power switch Off. Wait a moment, and turn On.
9. Next, install Printer Driver & Utility. See 3.2 Network Quick Install.
Note:
• For further information on Smart Organizing Monitor, please refer to the User Guide, p60.