RICOH SP 311SFNw B&W Multifunction Laser Printer
Getting Started Guide
13
Note:
• For NETGEAR routers, adding a WPS client (such as a printer) is performed through the
[ADVANCED] tab [WPS Wizard], as shown below.
f. Follow screen prompts to enter Client’s (printer’s) PIN, i.e., number you wrote down in step 1f.
3. On printer, press [Connect]. Display reads, PIN Executing….
4. When printer display reads, Connection to AP has Succeeded,
press [Exit] [Clear/Stop].
Note:
• If the connection succeeds, an IP address has been assigned to the printer. To confirm, see
Appendix B: Print Configuration Report
.
• If the connection fails, Connection to AP has Failed appears on the display, press [Exit] and
repeat from step 1. If the problem persists, contact 1-800-RICOH38 (742-6438), option #1.
5. Router web page should indicate, for example, “The wireless client [xyz] has been added to the
network successfully.” Click [Logout].
6. Turn printer power switch Off. Wait a moment, and then turn On.
7. Check wireless connection status. Press [User Tools] [Network Settings] [Wi-Fi] [Wi-Fi Status].
Display should read, Connected. To exit, press [Clear/Stop].
Note:
• Also see Appendix A: Check Wi-Fi Connection Status.
8. Next, install Network Printer/Scanner Drivers. See 3.2 Network Quick Install.
To Next Page
Loading...
