RICOH SP 311SFNw B&W Multifunction Laser Printer
Getting Started Guide
42
Appendix
D
Add New Port
If you would like to bypass the install wizard and have more control over printer port
creation, the steps for manually adding a port are outlined below.
Before proceeding, please check the following:
• Printer power switch is On.
• Network is connected and configured.
• Printer’s IP address is available. If necessary, see Appendix B: Print Configuration Report.
1. Click [Start] ï‚„ [Devices and Printers].
2. Right-click [RICOH SP 311SFNw] icon.
3. Select [Printer properties].
4. Select [Ports] tab.
5. Click [Add Port…].
To Next Page
Loading...
