3. Place the original on the exposure glass front side down and with the top to the rear of
the machine.
Place the originals one by one.
4. Press the [Start] key.
A message prompting you to place the original back side down on the exposure glass appears on
the display.
5. Place the original on the exposure glass with the back side faced down and with the top
to the rear of the machine.
6. Press the [Start] key again.
When all originals have been scanned, press the [Clear/Stop] key.
• After you load the original, press the [Start] key within the time specified in [System Auto Reset
Timer]. Otherwise, the job is canceled. For details, see page 206 "Administrator Settings".
• Sort is not available.
4. Copying Originals
88
To Next Page
Loading...
