Ricoh SP 4510 DN User Manual

Turning On/Off the Power
This section explains how to turn on/off the printer.
Turing On the Power
1. Make sure the power cord is firmly plugged into the wall outlet.
2. Push the main power switch.
CYN031
The power indicator turns on.
• After you switch the main power on, a screen may appear to indicate that the printer is initializing.
Do not switch the power off during this process. Initialization takes about three minutes.
Turning Off the Power
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord.
Pulling the cord can damage the power cord. Use of damaged power cords could result in fire
or electric shock.
• Do not press and hold the main power switch when turning off the printer. Doing so shuts down the
printer forcefully and may damage the hard disk and the SDRAM module, causing a malfunction of
the printer.
• Before unplugging the power cord plug, turn off the power switch and make sure the power switch
indicator turns off. Not doing so may result in damage to the hard disk or memory, leading to a
malfunction.
1. Getting Started
26

Ricoh SP 4510 DN Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Maximum Paper Capacity	1, 600 sheets
Duplex Printing	Yes
Memory	512 MB
Monthly Duty Cycle	150, 000 pages
Maximum Paper Size	A4
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, A6, B5, B6, Letter, Legal, Executive
PDL	PCL6, PostScript 3
Operating System Compatibility	Windows, Mac, Linux
Paper Capacity	600 sheets (1 x 500-sheet tray + 100-sheet bypass tray)