Ricoh SP 4510 DN User Manual

When You Cannot Print
Problem Cause Solution
Printing does not start. The power is off. For details about how to turn on
the main power switch, see
page 26 "Turning On/Off the
Power".
Printing does not start. The cause is displayed on the
screen of the control panel.
Check the error message or
warning status on the display
panel, and then take the
required action. For details
about solutions, see page 71
"When Messages Are
Displayed".
Printing does not start. The interface cable is not
connected correctly.
For details about how to
connect interface cables
correctly, see
"Connecting the Printer",
Operating Instructions.
Printing does not start. The correct interface cable is
not being used.
The type of interface cable to
use depends on the computer.
Be sure to use the correct one. If
the cable is damaged or worn,
replace it. For details about
interface cable, see
"Connecting the Printer",
Operating Instructions.
Printing does not start. The interface cable was
connected after the printer was
switched on.
Connect the interface cable
before turning on the main
power switch.
3. Troubleshooting
98

Ricoh SP 4510 DN Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Maximum Paper Capacity	1, 600 sheets
Duplex Printing	Yes
Memory	512 MB
Monthly Duty Cycle	150, 000 pages
Maximum Paper Size	A4
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, A6, B5, B6, Letter, Legal, Executive
PDL	PCL6, PostScript 3
Operating System Compatibility	Windows, Mac, Linux
Paper Capacity	600 sheets (1 x 500-sheet tray + 100-sheet bypass tray)