Ricoh SP 4510 DN User Manual

3. Close the rear cover.
CYN114
• Be sure to raise the envelope lever after printing on envelopes.
• If printed envelopes come out badly creased, load the envelopes in the opposite direction. Also,
configure the printer driver to rotate the print object 180 degrees.
Specifications of Envelopes
• Do not use window envelopes.
• Envelopes, especially those with glue on their flaps, may stick together. Fan the envelopes to
separate them before loading. If the envelopes still stick together, load them one by one. For the
envelope types that can be used with this printer, see page 38 "Paper Size Specifications" and
page 41 "Paper Type Specifications".
• Misfeeds might occur depending on the length and shape of the flaps.
• Before loading envelopes, press down on them to remove any air from inside, flattening out all four
edges. If they are bent or curled, flattening their leading edges (the edge going into the printer) by
running a pencil or ruler across them.
The method for loading envelopes varies depending on the orientation of the envelopes. Be sure to load
envelopes with the correct orientation.
Loading Envelopes
55

Ricoh SP 4510 DN Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Maximum Paper Capacity	1, 600 sheets
Duplex Printing	Yes
Memory	512 MB
Monthly Duty Cycle	150, 000 pages
Maximum Paper Size	A4
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, A6, B5, B6, Letter, Legal, Executive
PDL	PCL6, PostScript 3
Operating System Compatibility	Windows, Mac, Linux
Paper Capacity	600 sheets (1 x 500-sheet tray + 100-sheet bypass tray)