Message Cause Solution
"Excdd max. No. of pages(AT)" While printing a Sample Print,
Locked Print, Hold Print, or
Stored Print file, the maximum
page capacity was exceeded.
• Delete unneeded files
stored in the printer.
• Reduce the number of
pages to print.
"Exceeded max. No. of pages
for temporary/stored jobs."
While printing a Sample Print,
Locked Print, Hold Print, or
Stored Print file, the maximum
page capacity was exceeded.
• Delete unneeded files
stored in the printer.
• Reduce the number of
pages to print.
"Exceeded max. pages. Collate
is incomplete."
The number of pages exceeds
the maximum number of sheets
that can be used with Collate.
Reduce the number of pages to
print.
"Exceeded the maximum unit
count for Print Volume Use. The
job has been cancelled."
The number of pages the user is
permitted to print has been
exceeded.
For details about Print Volum.
Use Limit., see Security Guide.
"Failed to obtain file system." PDF direct printing could not be
performed because the file
system could not be obtained.
Turn off the main power switch
and then back on again. If the
message appears again,
contact your service
representative.
"File system is full." The PDF file does not print out
because the capacity of the file
system is full.
Delete all unnecessary files from
the hard disk, or decrease the
file size sent to the printer.
"HDD is full." The hard disk became full while
printing a Sample Print, Locked
Print, Hold Print, or Stored Print
file.
• Delete unneeded files
stored in the printer.
• Reduce the data size of the
Sample Print, Locked Print,
Hold Print, or Stored Print
file.
"HDD is full." When printing with the
PostScript 3 printer driver, the
hard disk capacity for fonts and
forms has been exceeded.
Delete unneeded forms or fonts
registered in the printer.
3. Troubleshooting
92
To Next Page
Loading...
Need help?
General
