Cannot connect with/ NetWare server. (106/206)
Connection with NetWare server is unavailable. Contact your network administrator.
Cannot print.
Check the file you want to print is a supported file type. Check for misfeeds and ask your network
administrator for help.
Cannot recognize SDRAM mod./ Please call service.
The printer could not recognize the installed optional memory.
Cannot set IPv4 within/ the same subnet range. (###)
The IPv4 address cannot be set within the same subnet ranges.
Change (tray name) to the following settings: A4 (Recycled)
The specified paper type is different from the paper type in the indicated tray. This message does not apply
to the bypass tray. Press [Change] to change the tray's settings, press [Job Reset] to reset the job, or press
[FormFeed] to force printing.
Check @Remote Line
Check the connection status of @Remote Line.
Check network/ settings. (103/203)
The IP address setting is incorrect. Check the IP address, subnet mask, and gateway address. For details,
see p.63 "Ethernet Configuration".
Connect failed:WirelessCard Turn power off, check card.
Check there is a wireless LAN board installed.
Check that it is a supported board. If it is, check it is installed correctly.
Install the correct board properly.
For details, see p.43 "Installing the Interface Units".
Cover Open. Please close the Front Cover.
Close the front cover.
Cover Open. Please close the Paper Exit Cover.
Close the paper exit cover.
Cover Open. Please close the Rear Cover.
Close the rear cover.
Current wireless card is not WPA compatible. (###)
The wireless LAN you are using is not compatible with WPA.
Error and Status Messages that Appear on the Control Panel
171
To Next Page
Loading...
