Device access violation may have occurred. Contact the administrator.
An attempt was made to access the printer from outside of the network.
Duplex mode is in off position for (tray name)
The duplex mode for the indicated tray is off; you can only use one-sided printing. Press [Change] to change
the tray's settings, press [Job Reset] to reset the job, or press [FormFeed] to force printing.
Ethernet Board Error
An error on the Ethernet board is detected. Pull out and then re-install the controller board. If the problem
persists, contact your sales or service representative.
Failed to connect to server for Remote Diagnostics.
The printer cannot communicate with Remote Communication Gate. Check the connection to the Remote
Server Gate.
Independent-supply toner
Independent-supply toner is set. Use toner recommended for this printer.
IPv6 Address already exists Link-local Address (109/209)
The same IPv6 address already exists. Contact your network administrator.
IPv6 Address already exists Stateless Address (109/209)
The same IPv6 address already exists. Contact your network administrator.
IPv6 Address already exists Manual Config. Address (109/209)
The same IPv6 address already exists. Contact your network administrator.
Load paper in (tray name) or [Cancel] to FormFeed. A4 (Recycled)
There is no paper in the specified tray. Load the specified paper in the tray, press [Job Reset] to reset the
job, or press [FormFeed] to force printing.
Load paper in (tray name) A4 (Recycled)
There is no paper in the specified tray. Load the specified paper in the tray, press [Job Reset] to reset the
job, or press [FormFeed] to force printing.
Login failed due to user lockout. Please contact the administrator.
Login failed because the wrong password was repeatedly used for login.
Netwrk connection failed./ Check IP Address.
The connection with the network has failed. Check that the IP address is correct.
Netwrk connection failed./ Contact the administrator.
The connection with the network failed. Contact the network administrator.
9. Troubleshooting
172
To Next Page
Loading...
