5. Execute color registration.
In executing color registration, the black adjustment will also be applied to cyan, magenta,
yellow and special color.
For details about color registration, see "Adjusting the Color Registration" in the Maintenance
and Management supplied with the machine.
• In 0105: [Perpendicularity Adjustment], you cannot individually adjust the image position on
sides 1 and 2.
• You cannot skew paper with 0105: [Perpendicularity Adjustment]. For details about adjusting
paper skew, page 91 "Paper Skew".
• If it is difficult to check and adjust the image position on the printed sheet, print one side of the
format used in page 170 "Aligning the Image Position on Side 2 to That on Side 1 (Using a
Template to Align the Image Position on Side 1 and 2)".
(b) Adjust the image position (If custom paper is used)
Adjust the vertical and horizontal image position so that the center (A) of the leading edge of the
image is aligned to the registration mark.
In [Advanced Settings] for the custom paper you are using, select 1101: [Image Position] and
adjust the image position.
• [Across Feed] of [Image Position: Side 1]
• [With Feed] of [Image Position: Side 1]
• For details about specifying settings in the [Adjustment Settings for Operators] menu, and
[Advanced Settings] menu, see the Adjustment Item Menu Guide.
• If the problem persists even though you have adjusted the setting to its maximum and minimum
values, contact your service representative.
11. Advanced Instructions
164
To Next Page
Loading...
Need help?
General
