2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
To follow the steps below, attach the decurler unit.
3. In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 0304: [Correct Output Paper Curl] to " Curl Correction Level".
To control the level of decurling, select "Small" if the present setting is "Off" or "Large" if the present
value is "Small".
4. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
• This folding error will not occur if uncurled paper is used or sheets that curl downward.
Folded Sheets Are Not Stacked Properly
Cause:
If a large number of half-folded multi-sheet is delivered, the edge of the sheets may bulge and some part
of the edge will be swollen. If this happens, other sheets loaded on the bulged paper may turn over in
the output tray.
This may occur if:
• Thick, relatively stiff paper is used.
• When 1231: [Print Speed] in [Advanced Settings] for the custom paper you are using is set to
[Low].
9. Post-Processing Option Troubleshooting
146
To Next Page
Loading...
Need help?
General
