Cause:
Transfer blur occurs due to speed fluctuation of the intermediate transfer belt.
This may occur if S mode is used.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then increase the value in [Clear/Special] and [White] of [S] by one step.
Yes Finished!
No Contact your service representative.
5. Image Quality Problem: Lines
52
To Next Page
Loading...
