INSTALLATION ENGLISH Translation of the Original
24
454522.68.07-01-E
27.06.2012
5 INSTALLATION
Caution!
• The safety notices contained in Chapter 1 must be complied with!
• In low storage temperatures (< 10 °C) allow for an appropriate acclimatisation
period before turning the unit on!
• Transport packaging to be removed before turning the unit on!
Installation of the P030 Chiller
The P030 Chiller is to be installed outdoors on a level, horizontal surface with adequate load
bearing capability.
Any attachments to the floor, intermediate spacers or anti-vibration mountings are not required. Any
national or local installation and mounting regulations must be complied with!
For different installation conditions, consult the manufacturer.
Notice!
• To ensure trouble-free operation of the P030 Chiller as well as to provide
adequate access for the performance of maintenance and repair work, minimum
clearances must be maintained when installing the unit. (See also Dimensions)
• These installation requirements ensure that the cooling air can be drawn in and
discharged without obstructions. It can thus be largely prevented that the air
discharged in upward direction is reintroduced into the chiller (air short-
circuiting).
• Moreover, adequate air changes for heat dissipation at the installation site must
be ensured.
To Next Page
Loading...