Rigol DG2000 Series User Manual

RIGOL
© 2006 RIGOL Technologies, Inc
User’s Guide for DG2000 Series
4-14
The Hop Frequency lower limit is 1μHz. If the specified Hop Frequency is lower than
1μHz, the system will adjust the Hop Frequency to 1μHz automatically.
FSK Rate upper limit = 100kHz
The FSK Rate upper limit is 100kHz. If the specified FSK Rate is greater than 100kHz,
the system will adjust the FSK Rate to 100kHz automatically.
FSK Rate lower limit = 2mHz
The FSK Rate lower limit is 2mHz. If the specified FSK Rate is less than 2mHz, the
system will adjust the FSK Rate to 2mHz automatically.
Phase deviation upper limit=360
o
The Phase deviation upper limit is 360
o
. If the specified Phase deviation is greater
than 360
o
, the system will adjust the Phase deviation to 360
o
automatically.
Phase deviation lower limit= 0
o
The Phase deviation lower limit is 0
o
. If the specified Phase deviation is less than 0
o
,
the system will adjust the Phase deviation to 0
o
automatically.
PM Frequency upper limit= 20kHz
The PM Frequency upper limit is 20kHz. If the specified PM Frequency is higher than
20 kHz, the system will adjust the PM Frequency to 20kHz automatically.
PM Frequency lower limit= 2mHz
The PM Frequency lower limit is 2mHz. If the specified PM Frequency is lower than
2mHz, the system will adjust the PM Frequency to 2mHz automatically.
Start Frequency upper limit = **
Different Source types have different Start Frequency upper lower. If the Carrier is a
Square or Sine wave, the Start Frequency upper limit is 400MHz; if the Carrier is a
Ramp wave, the Start Frequency upper limit is 400kHz; if the Carrier is an Arb wave,
the Start Frequency upper limit is 12MHz.
Start Frequency lower limit = 1μHz
The Start Frequency lower limit is 1μHz. If the specified Start Frequency is lower than
1μHz, the system will adjust the Start Frequency to 1μHz automatically.
Stop Frequency upper limit = **
Different Source types have different Stop Frequency upper limit. If the Carrier is a
Square or Sine wave, the Stop Frequency upper limit is 400MHz; if the Carrier is a
Ramp wave, the Stop Frequency upper limit is 400kHz; if the Carrier is an Arb wave,
the Stop Frequency upper limit is 12MHz.
Stop Frequency lower limit =1μHz
The Stop Frequency lower limit is 1μHz. If the specified Stop Frequency is lower than
1μHz, the system will adjust the Stop Frequency to 1μHzautomatically.
Center Frequency upper limit = **
Different Source types have different Center Frequency upper limit. If the Carrier is a

Rigol DG2000 Series Specifications

General

Brand	Rigol
Model	DG2000 Series
Category	Portable Generator
Language	English