Rigol DG2000 Series

RIGOL
© 2006 RIGOL Technologies, Inc
User’s Guide for DG2000 Series
2-39
Table 2-19 The Menu Explanations of the PM Parameters
Function
Menu
Settings Explanation
Type PM Phase Modulation
Internal Choose the Internal source.
SrcInt
SrcExt
external
Use the rear [Modulation In]
connector to choose the external
source.
Deviat.
Set the Phase Deviation between the
Modulating Waveform and the Carrier
Waveform, ranging from 0
o
to 360
o
Freq
Set the modulating waveform
frequency. Frequency Range:
2mHz~20kHz (Only Internal).
Shape
Sine
Square
Triangle
UpRamp
DnRamp
Noise
Arb
Press the function key Sine, Square
etc to choose different Shape of
waveform.
Note: When choose the external modulation, the menu PMFreq
and Shape will hide.
In the Graph Mode, the waveform is shown in figure 2-51.
Figure 2-51 The Waveform Parameter in the Graph Mode
Modulating
Frequency
Phase
Deviation