Rigol DM3068

RIGOL Chapter 2 Front Panel Operations
User’s Guide for DM3068
2-76
Press  I/O  RS232 to enter the following interface.
 Set: set RS232 interface parameters.
 Print: enable or disable the data output function.
1. To Set RS232 Parameters
Press Set to enter the following interface.
 Baud: select the desired baud rate from 1200, 2400, 4800, 9600, 19200,
38400, 57600 and 115200. The default is 9600. This setting is stored in
nonvolatile memory.
 Parity: select the desired parity from None, Odd and Even. The default is
None. This setting is stored in nonvolatile memory.
 HS: enable or disable the serial hardware handshake function. When it is
disabled, please do not connect DTR/DSR pins into a logic high level.
2. Print
Press Print to enter the following interface, from which you can turn on or off
the output of measured data from serial ports.