Chapter 2 Front Panel Operations RIGOL
User’s Guide for DM3068
Preset Mode
Preset mode applies to production lines for avoiding misoperations.
Press in any mode to enter the following interface, from which you can
choose a preset configuration from up to 10 groups. Note the configurations in this
interface correspond to the 10 groups of system configurations in the internal
memory ( Type Sys Setting).
Press Setn (n=1 to 10); if an effective configuration is stored in the storage unit
corresponding to this key, the beeper sounds and the instrument recalls the
configuration stored directly; if the storage unit selected is empty, the instrument
returns to the previous test state directly.
Press Setn, the multimeter stores the current measurement
configuration into the memory unit corresponding to the key using the set name
Setn.
Besides, you can recall or save preset configurations using function. For
details, please refer to “Save and Recall”.
To Next Page
Loading...
