RIGOL Chapter 3 Remote Control
User’s Guide for DM3068
Web Control
DM3068 confirms to LXI-C standard and can be remotely controlled via web page.
Please take the following steps.
1. Set the LAN
Connect the multimeter to LAN using network cable. Set and obtain the IP
address by referring to “Interface Configurations” in chapter 2.
2. Execute Remote Control
Input the obtained IP address in the internet explorer and enter the following
welcome interface. Then, click “Web Identification Indicator” and the beeper
sounds.
1) Press “Network Status” to enter the interface as shown in the figure below
to view the setting information about TCP/IP and network hardware.
To Next Page
Loading...
