Chapter 3 Remote Control RIGOL
User’s Guide for DM3068
Command Control
DM3068 can be remotely controlled using commands in two ways.
User-Defined Programming
Users can program and control the multimeter using standard SCPI (Standard
Commands for Programmable Instruments) commands. For more details about
commands and programming, please refer to the Programming Guide of DM3068.
Use Software Offered by RIGOL or Others
Users can use Ultra Sigma from RIGOL, Measurement & Automation
Explorer from NI (National Instruments Corporation) or Agilent IO Libraries
Suite from Agilent (Agilent Technologies, Inc.) to send commands to control the
instrument remotely.
DM3068 uses USB, LAN, RS232 or GPIB interface to communicate with PC. The
next part will introduce how to control the instrument remotely using Ultra Sigma
through various interfaces in details. To obtain the software and detailed operation
methods, please contact RIGOL salesman or technical support.
To Next Page
Loading...
