Rigol DS1000 Series Programming Guide

RIGOL
© 2008 RIGOL Technologies, Inc.
Programming Guide for DS1000/DS1000CA Series
2-34
5. :DISPlay:MNUStatus
Command Format:
:DISPlay:MNUStatus□{ON|OFF}
Explanation:
The command is to set the menu ON or OFF.
Query Format:
:DISPlay:MNUStaus?
Returned Format:
Query returns “ON” or “OFF”. The double quotes are not returned.
Example:
:DISPlay:MNUStatus□ON Set the menu on
:DISPlay:MNUStaus? Query returns “ON”
6. :DISPlay:SCReen
Command Format:
:DISPlay:SCReen□<scr>
Explanation:
This command is to set the screen as “Normal” or “Inverted”.
Query Format:
:DISPlay:SCReen?
Returned Format:
Query returns “NORMAL” or “INVERTED”. The double quotes are not returned.
Example:
:DISPlay:SCReen□NORMal Set the Display mode to NORMAL
:DISPlay:SCReen? Query returns “NORMAL”

Rigol DS1000 Series Specifications

General

Trigger Modes	Edge, Pulse, Video, Slope, Alternate
Timebase Range	5 ns/div to 50 s/div
Channels	2
Input Impedance	1 MΩ ±2%, 15 pF ±3 pF
Vertical Resolution	8-bit
Interfaces	USB Host, USB Device
Input Coupling	AC, DC, GND
Power Supply	100-240 VAC
Dimensions	303 mm