Rigol DS1000CA Series - Page 62

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-50
:CHANnel<n>:DISPlay {ON|OFF}
:CHANnel<n>:DISPlay?
Function Explanation:
The commands are used to set and query channels “ON” or “OFF”.
<n> is 1 or 2.
Returned Format:
Query returns 1/0 Thereinto, “1” indicates the channel is open, “0” indicates
the channel is closed.
Example:
:CHAN2:DISP ON Set the display of channel 2 on
:CHAN2:DISP? Query returns “ON”
4. :CHANnel<n>:INVert
Command Format:
:CHANnel<n>:INVert {ON|OFF}
:CHANnel<n>:INVert?
Function Explanation:
The commands are used to set and query the waveform invert “ON” or “OFF”.
Returned Format:
Query returns “ON” or “OFF”.
Example:
:CHAN2:INV OFF Set the waveform invert of channel 2 “OFF”
:CHAN2:INV? Query returns “OFF”.
5. :CHANnel<n>:OFFSet
Command Format:
:CHANnel<n>:OFFSet <offset>
:CHANnel<n>:OFFSet?