Rigol DS1000CA Series - Page 67

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-55
1. :MEASure:CLEar
Command Format:
:MEASure:CLEar
Function Explanation:
This command is used to clear the current value.
2. :MEASure:VPP?
Command Format:
:MEASure:VPP? [<source>]
Function Explanation:
This command is used to query the Peak-Peak value of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 6.48e+03, unit is V.
3. :MEASure:VMAX?
Command Format:
:MEASure:VMAX? [<source>]
Function Explanation:
This command is used to query the maximum value of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 3.24e+03, unit is V.
4. :MEASure:VMIN?
Command Format:
:MEASure:VMIN? [<source>]