Rigol DS1000CA Series - Page 68

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-56
Function Explanation:
This command is used to query the minimum value for the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as -3.24e+03, unit is V.
5. :MEASure:VAMPlitude?
Command Format:
:MEASure:VAMPlitude? [<source>]
Function Explanation:
This command is used to query the vamplitude value of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 6.48e+03, unit is V.
6. :MEASure:VTOP?
Command Format:
:MEASure:VTOP? [<source>]
Function Explanation:
This command is used to query the top value of the waveform. The options of
<source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 3.24e+03, unit is V.
7. :MEASure:VBASe?
Command Format:
:MEASure:VBASe? [<source>]