Programming Introduction RIGOL
Programming Guide for DS1000CA Series
Function Explanation:
This command is used to query the base value of the waveform. The options
of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as -3.24e+03, unit is V.
8. :MEASure:VAVerage?
Command Format:
:MEASure:VAVerage? [<source>]
Function Explanation:
This command is used to query the average value of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 2.67e-01, unit is V.
9. :MEASure:VRMS?
Command Format:
:MEASure:VRMS? [<source>]
Function Explanation:
This command is used to query the root-mean-square value of the waveform.
The options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 1.36e+06, unit is V.
10. :MEASure:OVERshoot?
Command Format:
:MEASure:OVERshoot? [<source>]
To Next Page
Loading...
