RIGOL Programming Introduction
Programming Guide for DS1000CA Series
Command Format:
:MEASure:PWIDth? [<source>]
Function Explanation:
This command is used to query the positive pulse width of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 5.00e-04, the unit is s.
17. :MEASure:NWIDth?
Command Format:
:MEASure:NWIDth? [<source>]
Function Explanation:
This command is used to query the negative pulse width of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 5.00e-04, the unit is s.
18. :MEASure:PDUTycycle?
Command Format:
:MEASure:PDUTycycle? [<source>]
Function Explanation:
This command is used to query the positive duty cycle of the waveform.
Generally, duty cycle is in terms of percentage, and the transformational
relation of the overshoot value and percentage is: PDUT*100. For example:
PDUT = 5.00e-1 mens this duty cycle is 50%.
Returned Format:
Such as 5.00e-01.
To Next Page
Loading...
