Programming Introduction RIGOL
Programming Guide for DS1000CA Series
19. :MEASure:NDUTycycle?
Command Format:
:MEASure:NDUTycycle? [<source>]
Function Explanation:
This command is used to query the negative duty cycle of the waveform. The
options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as 5.00e-01.
20. :MEASure: PDELay?
Command Format:
:MEASure:PDELay? [<source>]
Function Explanation:
This command is used to query the delay of channel 1 or channel 2 relative to
the positive edge. The options of <source> are CHANnel1 or CHANnel2.
Returned Format:
Such as <-1.00e-04.
21. :MEASure:NDELay?
Command Format:
:MEASure:NDELay? [<source>]
Function Explanation:
This command is used to query the the delay of channel 1 or channel 2
relative to the negative edge. The options of <source> are CHANnel1 or
CHANnel2.
Returned Format:
Such as <-1.00e-04.
To Next Page
Loading...
