Rigol DS1000CA Series - Page 74

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-62
22. :MEASure:TOTal
Command Format:
:MEASure:TOTal {ON|OFF}
:MEASure:TOTal?
Function Explanation:
The commands are used to set and query the On/Off state of all measurement
functions.
Returned Format:
Query returns “ON” or “OFF”.
Example:
:MEAS:TOT ON Set all the measurement functions “ON”
:MEAS:TOT? Query returns “ON”
23. :MEASure:SOURce
Command Format:
:MEASure:SOURce <source>
:MEASure:SOURce?
Function Explanation:
The commands are used to set and query the current channel. The options of
<source> are “CHANnel1” or “CHANnel2”.
Returned Format:
Query returns “CH1” or “CH2”.
Example:
:MEAS:SOUR CHAN1 Measure the waveform of “CHANnel1”
:MEAS:SOUR? Query returns “CH1”