Rigol DS1000CA Series Programming Guide

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-64
1. :WAVeform:DATA?
Command Format:
:WAVeform:DATA? [<source>]
Function Explanation:
This command is used to read the waveform datum from the designated
source. The options of <source> are CHANnel1, CHANnel2, MATH or FFT.
Returned Format:
Query returns 600 points when selecting CHANnel1, CHANnel2 and MATH;
While query retures 500 points when selecting FFT.
2. :WAVeform:MEMORYDATA?
Command Format:
:WAVfeorm:MEMORYDATA? [<source>]
Function Explanation:
This command is used to read the waveform data from the designated source.
In STOP state, the waveform datum come from the memory. 10k datum can
be read in half-channel* state and 5k in other states.
In RUN state, the waveform datum come from the screen.
The options of <source> are CHANnel1 or CHANnel2.
Note*: The half-channel state means only one channel is open, the
MATH function is closed and the timebase should be less than 20ns.
Returned Format:
Query returns the data have been read.
3. :WAVeform:POINts:MODE
Command Format:
:WAVeform:POINts:MODE <points_mode>
:WAVeform:POINts:MODE?
Function Explanation:

Rigol DS1000CA Series Specifications

General

Brand	Rigol
Model	DS1000CA Series
Category	Test Equipment
Language	English