Rigol DS1000CA Series - Page 79

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-67
1. :KEY:LOCK
Command Format:
:KEY:LOCK {ENABle|DISable}
:KEY:LOCK?
Function Explanation:
The commands are used to enable or disable the remote control of the front
panel keys.
Returned Format:
Query returns “ENABLE” or “DISABLE”.
Example:
:KEY:LOCK ENAB Enable the key on the front panel
:KEY:LOCK? Query returns “ENABLE”
2. :KEY:RUN
Command Format:
:KEY:RUN
Function Explanation:
This command is used to control the RUN/STOP mode of the oscilloscope.
Repeating the command would make the oscilloscope switched between RUN
and STOP.
3. :KEY:AUTO
Command Format:
:KEY:AUTO
Function Explanation:
This command is equivalent to the AUTO key, which enables the oscilloscope
to set the optimum conditions to display the input signal (waveform).