Rigol DS1000CA Series - Page 80

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-68
4. :KEY:CHANnel1
Command Format:
:KEY:CHANnel1
Function Explanation:
This command is used to set the on-state for Channel 1 and its menu .
Repeating the command would make the channel switched between ON and
OFF.
5. :KEY:CHANnel2
Command Format:
:KEY:CHANnel2
Function Explanation:
This command is used to set the on-state for Channel 2 and its menu .
Repeating the command would make the channel switched between ON and
OFF.
6. :KEY:MATH
Command Format:
:KEY:MATH
Function Explanation:
This command is used to set the on-state for MATH function and its menu.
Repeating the command would make the function switched between ON and
OFF.
7. :KEY:REF
Command Format:
:KEY:REF
Function Explanation: