Rigol DS1000CA Series - Page 81

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-69
This command is used to set the on-state for waveform reference function
and its menu. Repeating the command would make the reference switched
switch between ON and OFF.
8. :KEY:F1
Command Format:
:KEY:F1
Function Explanation:
This command is similar to press and select the option of Menu F1.
Repeating this command would enter next level of menu.
9. :KEY:F2
Command Format:
:KEY:F2
Function Explanation:
This command is similar to press and select the option of Menu F2.
Repeating this command would enter next level of menu.
10. :KEY:F3
Command Format:
:KEY:F3
Function Explanation:
This command is similar to press and select the option of Menu F3.
Repeating this command would enter next level of menu.
11. :KEY:F4
Command Format:
:KEY:F4