Rigol DS1000CA Series - Page 99

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-87
3. :BEEP:ENABle
Command Format:
:BEEP:ENABle {ON|OFF}
:BEEP:ENABle?
Function Explanation:
The commands are used to set and query the beeper function “ON” or “OFF”.
Returned Format:
Query returns “ON” or “OFF”.
Example:
:BEEP:ENAB ON Set the beeper ”ON”
:BEEP:ENAB? Query returns “ON”
4. :BEEP:ACTion
Command Format:
:BEEP:ACTion
Function Explanation:
This command is able to make a beep once (no matter whether it is opern or
not).