Rigol M300 - Rear Panel

RIGOL
M300 Quick Guide
7
Rear Panel
Figure 4 Rear Panel
1. Slots
M300 provides 5 slots for 5 modules and only one DMM module is permitted for
one mainframe. The 5 slots from left to right in the figure above correspond to
the 5 module indicators at the front panel respectively. When a module is
inserted in the slot, the corresponding module indicator at the front panel goes
on. Figure 4 is the schematic diagram of the rear panel without the modules
inserted. For information of each module, refer to “Plug-in Module
Overview”.
2. USB Device
Via this interface, M300 can communicate with the PC as a slave device and you
can control it remotely via the PC.
3. LAN
M300 conforms to the LXI-C instrument standard. The instrument can be
connected to the network via this interface and you can control the instrument
remotely via a PC in the same network.
4. Analog Bus Interface (Female)
M300 provides two internal 2-wire analog buses for signal routing as well as an
external interface (namely Analog Bus Interface). The analog bus interface is a
9-pin female interface.
1 2 3 4 5
9
10
6
7
8