Rigol M300 - Basic Operations; Measurement Connections; Using External Terminal Blocks

RIGOL
M300 Quick Guide
23
Basic Operations
This section introduces the basic operations of M300, including how to connect the
signals to be measured, how to configure the scan list as well as the remote control
method.
Measurement Connections
Using External Terminal Blocks
M300 provides 6 kinds of terminal blocks to easily connect the signal to be measured
to the module. The models of the terminal blocks and its corresponding modules are
listed in the table below. This section introduces how to use the external block.
Terminal Block
Module
1 TB32 MC3132, MC3232
2 TB64 MC3164, MC3264
3 TB24 MC3324
4
TB48
MC3648
5
TB16
MC3416
6 TB34 MC3534
Note: for MC3724, the signal can be connected to the SMB connectors on the
module directly and no terminal block is needed.
WARNING
Cut off all the power supplies before opening the terminal block or
removing the terminal block from the module.
1. Place the terminal block with the front (with the RIGOL caption) facing
downward and pull the two latches in the arrow direction in the figure below and
press them down. Place the terminal block with the front facing upward and pull
the upper cover of the terminal block upward and remove it.