DMM “ON”). The channel must also be configured to be part of the scan
list. You can monitor a DIO or TOT channel even if the channel is not part of the
scan list.
2． Multi-channel Monitor
Press Monitor Multiple to enter the multi-channel monitor interface. At
most 7 channels can be monitored. You can add or delete the channels being
monitored.
3． All Channel Monitor
Press Monitor All Moni to enter the all channel monitor interface. All
channels in the scan list can be monitored.
Remote Control
M300 can communicate with PC through USB, LAN, GPIB and RS232 (converted from
the [RS-232/Alarms/Ext Trig] interface at the rear panel of M300) to realize
remote control based on the SCPI (Standard Commands for Programmable
Instruments) commands. This section introduces how to use Ultra Sigma to control
the instrument remotely through USB interface. For the detailed information about
the SCPI commands, please refer to the Programming Guide.
1. To install Ultra Sigma
Download the Ultra Sigma common PC software from
www.rigol.com and install
it according to the instructions.
2. To control the instrument via USB
(1) Connect the devices
Connect the USB Device interface of M300 to the USB Host interface of your
computer using the USB cable.
(2) Install the USB driver
This instrument is a USB-TMC device. After you connect it to the PC and
turn both on for the first time, the New Hardware Wizard is displayed on the
PC. Please install the “USB Test and Measurement Device” driver following
the directions in the wizard.
(3) Search device resource
Start up the Ultra Sigma and the software will automatically search for the
power supply resources currently connected to the PC. You can also click
to search the resources.
(4) View the device resource
The resources found will appear under the “RIGOL Online Resource”
To Next Page
Loading...
