RIGOL
M300 Quick Guide
32
directory and the model number and USB interface information of the
instrument will also be displayed as shown in the figure below.
(5) Communication test
Right click the resource name “M300
(USB0::0x1AB1::0x0C80::M3001111333::INSTR)” to select “SCPI Panel
Control” to turn on the remote command control panel (as shown in the
figure below) through which you can send commands and read data.
Note: When the instrument is in remote mode, Rmt is displayed in the status bar in
the user interface and all the keys except are locked. At this point, press
to exit the remote mode.
To Next Page
Loading...
