Rigol M300 - Insert the Module into the Mainframe

RIGOL
M300 Quick Guide
14
Insert the Module into the Mainframe
Please turn the mainframe off firstly and insert the modules following the instructions
below.
As shown in Figure 6, there is a golden circuit board edge both on the top and
bottom of the module. Aim the two edges with the sliding chutes (as pointed out by
the arrows in the figure below) in the main frame slot and push the module in until
you hear a sound. At this point, interface 2 is connected to the main frame.
Note: please refer to “Measurement Connections” to connect the external
terminal block and the signals to be measured and then insert it into the mainframe.
Figure 7 Insert the Module into the Mainframe
Note:
All the modules of M300 do not support hot-plugging. Please turn the mainframe
off before inserting the modules into the mainframe.