Rigol M300 - To Connect the Signal to be Measured

RIGOL
M300 Quick Guide
26
To Connect the Signal to be Measured
The signals to be measured are connected to the plug-in modules via the external
terminal blocks. The connection methods of all kinds of signals are listed in Table 1.
Table 1 Measurement Connections
DCV/ACV/FREQ/PERIOD/Sensor
(DCV, FREQ)
+ -
Signal to be
measured
H L
CH1
DCI/ACI/ Sensor (DCI)
+ -
Signal to be
measured
H L
CH21
Note: Only available for the channel 21 to
channel 24 of MC3324.
2WR/RTD/Thermistor/
Sensor (2WR)
+ -
Resistance to be
measured
H L
CH1
4WR/4WR RTD/ Sensor (4WR)
H L Source
CH1
H L Sense
CH17
Note: Only available for all the channels of
MC3132 and MC3232 as well as the channel 1
to channel 20 of MC3324.
Thermocouple
+ -
Thermocouple
under test
H L
CH1
Resistance to be
measured
+
+
-
-