Configuration Copy
M300 provides configuration copy function (including module copy, channel copy and
extended copy) which can configure multi channels with same configuration to the
scan list easily and quickly. Press Config Edit Copy to enter the copying
interface.
1． Module Copy:
Copy the configuration of a module (source module) to another module (target
module) of the same model. After that, the configuration of each channel of the
source module is copied to the target module automatically.
Press Module in the copying interface to enter the module copy interface.
(1) The “Source Module” area is selected by default. Use the up/down direction
keys to select the desired source module.
(2) Press Switch to move the cursor to the “Target Module” area and use the
up/down direction keys to select the desired target module.
(3) Press OK to execute module copy.
Note: the source module and target module selected must be of the same
model and it is forbidden to copy the configuration of a module to itself.
2． Channel Copy:
Copy the configuration of a channel (source channel) to another channel (target
channel) of the same type.
Press Channel in the copying interface to enter the channel copy interface. The
channel selected is fixed as the source channel and the upper area is selected by
default. At this point, use the left/right direction keys to select the desired target
channel, press OK to confirm it (press OK again to cancel it) and press Done to
execute channel copy.
You also can press Switch to fix the channel selected as the target channel
after entering the channel copy interface. At this point, the lower area is
selected. Use the left/right direction keys to select the desired source channel
and press Done to execute channel copy.
Tips:
(1) When the channel selected is fixed as the source channel, multiple target
channels can be selected and are displayed in the lower area.
(2) When the channel selected is fixed as the target channel, only one source
channel can be selected.
(3) The Switch menu is gray and disabled if the scan list only has one channel.
Note: For channel copy, only copies between the same type of channels
To Next Page
Loading...
