Rigol M300 - Page 36

RIGOL
M300 Quick Guide
28
configuration;
Select A, B and C and use the numeric keyboard to input the desired
scaling coefficients;
Select x1 and press Curr Value to acquire x1.
Select Unit and input the desired unit.
Note: for multiplexer channel using the “SENSOR” function and the DIO
and TOT channels of the multifunction module, the configuration guide
does not contain scaling configuration. Besides, for multiplexer channel, if
the DMM module is not currently inserted or it is inserted but is not enabled,
the configuration guide also does not contain “Scaling Configuration” when
you connect an external DMM to execute scan and measurement.
(3) Step 3: Alarm Configuration
Select Mode and use the left/right direction keys to select the desired
alarm mode (for example, HI);
Select Channel and use the left/right direction keys to select the desired
alarm channel (for example, Alarm1);
Select HI or LO and use the numeric keyboard to input the desired alarm
limit (for example, 12).
Note: for multiplexer channel, if the DMM module is not currently inserted
or it is inserted but is not enabled, the configuration guide does not contain
“Alarm Configuration” when you connect an external DMM to execute scan
and measurement.
(4) Step 4: Advanced Configuration
Note: The parameters needed to be set in this step are depended on the
selected function.
Select Integ and use the left/right direction keys to select the desired
integration time (for example 1PLC);
Select IMP and use the left/right direction keys to select 10MΩ or >10GΩ;
Select AZ and use the left/right direction keys to select “ON” or “OFF”;
Select Delay and use the left/right direction keys to “Auto” or set the delay
time manually.
Press Done to finish the channel configuration guide and return to the scan
list edit interface.
4． Configure other channels to the scan list
Press New and configure other channels to the scan list according to the step 3.
5． Save the scan list
After the scan list configuration is completed, press Save to save the configured
scan list in internal or external memory