EasyManuals Logo

Rigol MSO1000Z series User Manual

Rigol MSO1000Z series
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
RIGOL Chapter 6 MATH and Measurement
6-10 MSO1000Z/DS1000Z User’s Guide
Fx Operation).
Note: Smooth is grayed out and disabled. It is only available for differential
operation.
You can also use HORIZONTAL POSITION and HORIZONTAL
SCALE to adjust the horizontal position and scale of the operation results.
OROperation
Perform logic ORoperation on the waveform voltage values of the specified
sources point by point and display the results. In operation, when the voltage value
of the source channel is greater than the threshold of the corresponding channel, it is
regarded as logic “1”; otherwise logic 0”.
The results of logic OR operation of two binary bits are as follows.
Table 6-3 Logic OROperation
A
B
A||B
0
0
0
0
1
1
1
0
1
1
1
1
Press MATH Math Operator to select “A||B”:
Press Operation to enable or disable the ORoperation function.
Press SourceA and SourceB to select the desired channels (CH1-CH4 or
D0-D15).
If source A selects any channel in CH1-CH4, press Thre.A and use set
the threshold of source A in logic operation. If source A selects any channel
in D0-D15, Thre.A will be hidden automatically.
If source B selects any channel in CH1-CH4, press Thre.B and use set
the threshold of source B in logic operation. If source B selects any channel
in D0-D15, Thre.B will be hidden automatically.
Press Offset and use to adjust the vertical position of the operation results.
Press Scale and use to adjust the vertical scale of the operation results.
Press Scale Reset to adjust the vertical scale of the operation results to the
optimal value according to the current configuration.
Press Options to set the start and end points of the operation results, enable or
disable waveform invert, etc.
Press Start and use to set the start point of the operation results.
Press End and use to set the end point of the operation results.
Press Invert to enable or disable the inverted display function of the
waveform.
Press Sens. and use to set the sensitivity of the digital signal converted
from the analog signal on the source. The setting range is from 0.00 Div to

Table of Contents

Other manuals for Rigol MSO1000Z series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rigol MSO1000Z series and is the answer not in the manual?

Rigol MSO1000Z series Specifications

General IconGeneral
BrandRigol
ModelMSO1000Z series
CategoryTest Equipment
LanguageEnglish

Related product manuals